Skip to content

DM 700 Head / Wall Mount Loop

ATEX Approved Loop Powered LED Indicator

  • Powered from an existing current loop
  • 4 Digit LED Display
  • Fully Programmable by Push Buttons
  • ATEX Version available
Categories: ,

The DM700 is a loop powered indicator which incorporates a high efficiency LED display. Designed for use with our SCH4 ABS heads and SCH15 stainless steel head (non ATEX)
available. The units are sealed to IP67.
The DM700I is microprocessor based and set-up is achieved by means of three push buttons, located on the back of the display module inside the housing. By following a simple menu structure, this device can have a number of standard linearisations applied, such as square root, or a custom characteristic can be entered.

FEATURE HIGHLIGHTS
LOOP POWERED

The instrument is powered by the (4 to 20) mA loop current and can be connected at any point in the control loop circuit. The DM700I draws a minimal load from the loop needing no additional power supply.

ATEX

An ATEX version is available for use in hazardous gas and dust areas (ABS housing only).

ADJUSTABLE RESOLUTION

Display resolution to 0000, 000.0, 00.00 or 0.000

TEMPERATURE TRANSMITTER COMPATIBLE

As well as working with any (4 to 20) mA signal the DM700I has space inside its housing to mount a standard 33 mm centre, head mount, (4 to 20) mA temperature transmitter.
Any of the Status Instruments range of temperature transmitters can be used with the DM700I to give a local temperature display.

HART TRANSPARENT

If connected to a HART (4 to 20) mA control loop HART messages will pass through the DM700I.